mini PCI-E Adapters

The unit provides 2-port Mini PCI-e SSD connector, built-in 2.5-inch shell SATA II high-performance array card. It provides hardware to setup the RAID level, no driver, BIOS or software required for RAID installation, can be switched to RAID 0, RAID 1, JBOD three mode operation settings. 

Adapter for converting a Mini PCIe slot to two USB 2.0 interfaces. Is compatible with any mini PCIe interface and no drivers are required. Note: does not support USB 3.0 devices.

The mini PCIe extender is a debug and test tool.  The design of the FFC (Flat Flexible Cable) cable is for flexible use.  Not only for used for a full-size Mini Card adapter but also for Half-size Mini Cards by removing the extra full-size extensions. The mini PCI-Extender card is designed to minimize the signal degradation effects of the extender by proven design techniques.  It is also a powerful tool for engineers and factory tests.

The SATA II, III to mini PCI-e SSD adapter is designed to provide an interface between the SATA II, III and the mini PCI-e 52-pin Bus SATA interface standard.   Works with DOS, Windows 95, 98, XP, 2000, Win 7, Linux, Unix, allowing the operating system to boot and run from a mSATA module.

The SATA II, III to mini PCI-e SSD adapter is designed to provide an interface between the SATA II and the mini PCI-e 52-pin Bus SATA interface standard.  Works with DOS, Windows 95, 98, XP, 2000, Win 7, Linux, Unix, allowing the operating system to boot and run from a mSATA module.

This adapter is an mSATA SSD HDD to 20+6pin as a SanDisk/Toshiba/Intel SSD for Lenovo X1 Carbon Ultrabook. It is used to convert mSATA SSD as 26 Pin SSD for Lenovo X1 Carbon Ultrabook.